Instruction Manual
8.2 START pushbutton
The START pushbutton is used to:
- start the Radio Remote Control (see paragraph 8.11),
- activate the horn when the Radio Remote Control is started.
8.3 STOP pushbutton
When the STOP pushbutton is activated, the Machine stops and the Transmitting Unit switches
o. To start the Radio Remote Control again and enable it to control the Machine after the
STOP pushbutton has been pressed, you need to:
- make sure that the working and usage conditions are safe,
- pull or turn the STOP pushbutton in the arrow direction (show on the button) to unlock it,
- start the Radio Remote Control following the procedure described in paragraph 8.11.
The STOP pushbutton should be pressed when it is necessary to stop the
Machine immediately whenever a dangerous condition occurs.
The Machine Manufacturer and/or the Installer must provide the User with the
instructions and warnings concerning possible risks that may originate from
the Machine stop (by way of example: movement inertia, swinging load…).
8.4 FUNCTION pushbutton
The function of the FUNCTION pushbutton is decided by the Installer of the Radio Remote
Control. The Machine Manufacturer and/or the Installer must provide the user with instructions
about the relation between the FUNCTION pushbutton and the corresponding movement on
the Machine. The User must be properly trained about this.
8.5 DISPLAY pushbutton (if the Transmitting Unit has a display)
The functions of this pushbutton are:
- Activates the display lighting.
- It cyclically scrolls the information on the display in two dierent modes:
- Manual: the lines scroll up each time the pushbutton is pressed.
- Automatic: when the DISPLAY pushbutton is pressed for 3 seconds, the lines scroll
automatically. If the DISPLAY pushbutton is pressed again, it switches back to Manual
mode.
It is not possible to scroll the lines if icons only are displayed.
The display lighting stays on for a time set by the Machine Manufacturer.
No function other than the above mentioned functions must be given to the
display pushbutton when the Unit is installed.
28
LIULK6ES0_eng-01
General operating instructions
AUTEC - Air series