User's Manual
AUTEC - Air series
Conformity 3
LIAIRE12-03
Unit FCC ID IC Number
Receiving unit L
ACRS13-L
OQA-RLBHA00M
d
9061A-RLBCA00M
a
b
c
Receiving unit M
ACRM15
OQA-RMCEA00M
d
9061A-RMCEA00M
a
b
c
Receiving unit
HACRP8
OQA-RPDFA00M
d
9061A-RPDFA00M
a
b
c
Receiving unit
MVRCAN
OQA-RNFLA00M
d
9061A-RNFLA00M
a
b
c
Receiving unit
MVRL9E
OQA-RRLPA00M
d
9061A-RRLPA00M
a
b
c
Receiving unit
DCRM24
OQA-RMGMA00M
d
9061A-RMGMA00M
a
b
c
Receiving unit
ACRM5E
OQA-RMHN00M
d
9061A-RMHNA00M
a
b
c
a. Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
b. This radio transmitter has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for each antenna
type indicated. Antenna types not included in this list, having a gain greater than the maximum
gain indicated for that type, are strictly prohibited for use with this device.
Antenna type Antenna gain Antenna impedance
Autec stylus λ/4 <0dBi 50 Ohm
c. Autec allows you to use only the dedicated antenna supplied either with the remote control or
as original spare part. The use of any other type of antenna is prohibited and will invalidate the
guarantee.
d. Place the antenna of the receiving unit in a position that ensures a minimum separation distance
of 20cm with all the people that can be in the working area.
1.2.1 Federal Communications Commission (FCC)
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.