User's Manual
AUTEC - Air series
Warnings for installation 15
LIAIRE02-01
3.5 At end of installation
Make sure that during installation the protection measures on the radio
remotecontroland/orinthemachinehavenotbeenmadeineectiveby
possible procedures carried out.
Look up in the technical data sheet and check that the frequency band set
in the radio remote control is permitted in the country of use.
Correctly close the receiving unit so that the protection degree from dust
and water is not jeopardised: check that the gasket is intact, correctly put the
housing parts one over the other so that they overlap, and tighten the screws.
3.6 Testing
The installer must check and complete the technical data sheet in all its parts, adding the
date the system has been put into service, his stamp and signature.
After installing and wiring the receiving unit, test the system “machine+radio
remotecontrol”,andcheckthattheoperationscarriedoutcorrespondexactly
to the commands sent (in particular check the STOP command).
Incaseofmalfunction,disablethesystem“machine+radioremotecontrol”
until the problem has been completely solved.