User's Manual

8
LILK6E00-01
General operating instructions
AUTEC - Air series
6.1.2 PIN CODE start up (no power keyswitch)
Considerthatthetransmittingunitwillswitcho󰘯3secondsafterlastactivation
of an actuator.
When the receiving unit is powered on, perform the following procedure:
1. press the START pushbutton until the green LED illuminates
2. activate the commands corresponding to PIN CODE in the correct sequence (PIN 1, PIN
2 and PIN 3 given in the technical data sheet).
a. PIN 1 shall not be included in the start up procedure if it coincides with the START
command.
b. PIN 3 shall not be included in the start up procedure if it coincides with the START
command.
3. press the START pushbutton until the green LED blinks slowly.
Note: default PIN CODE set by AUTEC is:
- PIN 1=START pushbutton
- PIN 2=FUNCTION pushbutton
- PIN 3=START pushbutton.
CustomPINCODEissetbyAutecuponrequestbythemachine'smanufacturerorbythose
who decided to install the radio remote control.
6.1.3 Power keyswitch and PIN CODE start up
When the receiving unit is powered on, perform the following procedure:
1. Insert a charged battery in the transmitting unit (see paragraph 7.1.1)
2. insert the power keyswitch in the transmitting unit (see paragraph 7.3.3).
Considerthatthetransmittingunitwillswitcho󰘯3secondsafterlastactivation
of an actuator.
3. press the START pushbutton until the green LED illuminates
4. activate the commands corresponding to PIN CODE in the correct sequence (PIN 1, PIN
2 and PIN 3 given in the technical data sheet).
a. PIN 1 shall not be included in the start up procedure if it coincides with the START
command.
b. PIN 3 shall not be included in the start up procedure if it coincides with the START
command.
5. press the START pushbutton until the green LED blinks slowly.