Instruction Manual
8.3.1 Indication of the SK4 Unit's battery charge level
Perform the following procedure to check the SK4 Unit's battery charge level:
1. switchotheTransmittingUnitandunlocktheSTOPpushbutton,
2. activate command S1 (check in the Technical Data Sheet which actuator it corresponds
to) and enable START until LED 1, LED 2 and LED 3 (indicating the battery charge
level) illuminate:
- 1 LED on: low level
- 2 LEDs on: medium level.
- 3 LEDs on: maximum level.
The charge level indication disappears after some seconds.
Commands associated to the actuators that are activated during the procedure
to check the battery charge level are not sent to the Machine.
8.4 ID internal tx memory
The "ID internal tx memory" is a key containing the address that is used to code messages
exchanged between the Transmitting Unit and the Receiving Unit.
This key is inside the Transmitting Unit.
The Technical Data Sheet indicates if the "ID internal tx memory" is present (DIP switch 2
is set in the ON position).
S/N:
XXXXXXX
S/N:
XXXXXXX
A
A ID internal tx memory
20
LIUSK4N01_eng-01
General operating instructions
AUTEC - AIR SERIES