Instruction Manual

8.8 Using the Transmitting Unit while recharging
The SK4 Unit may or may not be enabled to control the Machine while the Unit itself is being
charged.
This activation depends on the "Charger Plug Enable" setting. Autec sets this function only
upon request by the Installer and under his own responsibility.
Check the Technical Data Sheet to know if this setting is enabled.
8.8.1 "Charger Plug Enable" setting is enabled
When the "Charger Plug Enable" setting is enabled and the Radio Remote
Control is started, the SK4 Unit can always send commands. In this case,
the Stop function is always available.
If the SK4 Unit is used non-stop (Radio Remote Control always started and
Unit always under charge), switch o󰓐 the Transmitting Unit at least every
24 hours.
The Unit's recharge may not end (the green CHARGE LED may not illuminate)
when all following conditions occur:
- the Transmitting Unit is being charged,
- the "Charger plug Enable" setting is active,
- the Radio Remote Control is started.
This is due to the permanent current absorption of the working Transmitting
Unit.
8.8.2 "Charger Plug Enable" setting is not enabled
When the "Charger Plug Enable" setting is not enabled, it is not possible to start the Radio
Remote Control while recharging the Unit. Therefore, the SK4 Unit cannot control the Machine
and the Stop function is not available. In this case, when you need to recharge the battery,
makesurethattheMachineisinsafetyconditions,sothatitcannotgeneratehazards.
24
LIUSK4N01_eng-01
General operating instructions
AUTEC - AIR SERIES