Instructions / Assembly

15
perform the I/M readiness monitor status quick-check to determine if
the tested vehicle is ready for an emission test.
Use the SCROLL button to select Scan Tool Mode or Ready Test
Mode and press the ENTER button to save your selection and return
to previous screen.
1) Scan Tool Mode
Scan Tool Mode is the default work mode. In this mode, after the
vehicle‟s monitors have run and completed their diagnosis and testing,
the scan tool will turn to OBDII diagnostic procedures. The detailed
functions are described below.
The monitor status refreshes every 2 minutes.
2) Ready Test Mode
In this mode, after the vehicle‟s monitors have run and completed
their diagnosis and testing, the scan tool will return to the previous
screen. So it is mostly used to check the monitors‟ status.
The monitor status refreshes every 2 minutes.
Configure Monitors
From System Setup screen, use the SCROLL button to select
Configure Monitors, and press the OK button.(Figure 3.5 )
Figure 3.5
Configure Monitors 1/3
Allowed INC Monitors
Reset Factory Default
Previous Menu