User's Manual

[Operate: Set Config] – Sets the network configuration of the

Pass-Thru device.

[Operate: Get Config] – Obtains the saved network configuration from

the Pass-Thru device.

5) Click on ―Wire‖ in ―Net‖ column.

6) Select ―DHCP‖ in ―Mode‖ column, if you are connecting to the

local area network, the MaxiFlash Pro will obtain the IP address

automatically. Select ―Manual‖ in ―Mode‖ column, if you are

connecting to the PC directly for the first time, and then set the IP

address on your own. (Take the value shown in Figure 3.5 for

example).

7) Select ―Set Config‖ in ―Operate‖ column to allow setting the

network configuration through PC application.

8) Click on ―OK‖ button to save the network configuration.

Figure 3.5

3.2.3 MaxiFlash Configuration – Wireless Network

1) Power up the device by the external power supply; verify if the

green Power status light at the front panel is on.