User's Manual

2) Click on ―All Program‖ from Windows Start Menu, find the

―Maxi Flash‖ entry under ―Autel intelligent tec inc‖, click on

―MaxiFlashCFG‖, and wait for the program interface to pop up.

(Figure 3.4)

3) Click on ―Wireless‖ in ―Net‖ column.

4) Select ―On‖ in ―Power‖ column to turn on wireless connection.

5) Select ―DHCP‖ in ―Mode‖ column to enable MaxiFlash Pro to

obtain the IP address automatically. Select ―Manual‖ to set the IP

address on your own.

6) Select ―Set Config‖ in ―Operate‖ column to allow setting the

network configuration through PC application.

7) Fill in the specific Essid and Password information of your

wireless network, and click ―OK‖ button to save the network

configuration.

3.2.4 Setup Pass-Thru Device as Wi-Fi Hotspot

By ticking the ―AP‖ - (Access Point) - option at the bottom of the

―Maxi Flassh Config‖ interface window, this function will setup the

Pass-Thru device to serve as a Wi-Fi hotspot itself, which will allow

other PCs to access to the device network directly through wireless

connection.

1) Select ―Set Config‖ in ―Operate‖ column to allow setting the

network configuration through PC application.

2) Tick on the ―AP‖ option at the bottom of the interface window.

3) Fill in a custom Essid name, e.g. MaxiFlash Pro, or other ID

name you like.

4) Set a custom network access password.

NOTE: The program default setting requires the password to be

either of 5 or 13 characters, which is case sensitive.

5) Click on ―OK‖ button to save the wireless AP configuration.