User's Manual

21
In one wheel mode, the tool will do TPMS test for single wheel. Place
the tool alongside the valve stem and point toward the sensor location
and then press TEST BUTTON.
The tool will send LF signal to trigger the sensor. Depending on the
sensor type, the tool will activate the sensor on the first or last step.
Once the sensor is successfully activated and decoded, the tool will
display as below with an audible beep. (Figure 3.10)
Figure 3.10
Once the first sensor test is completed, the screen will hold for 3
seconds for data viewing and then switch to next sensor test. Follow
the same procedure for the other sensor tests by pressing UP/DOWN
SCROLL button and then TEST BUTTON.
The tool can save up to 5 TPMS sensor data records at each time. Press
UP/DOWN or LEFT/RIGHT scroll button to turn over data screens
while viewing. If sensors being tested are more than five pieces, the
latest record will overwrite the first one.