User's Manual

c) Confirm there‟s no vehicle with TPMS sensors around the

vehicle being served within 3 meters (9 feet). Press the Y button

to continue or the N button to exit.

d) Follow the same sensor testing procedure in All Wheel Mode to

finish sensors activation.

e) After the sensors are successfully activated, follow the

instruction screen to connect the tool with the vehicle‟s DLC

again through the OBDII Cable and turn the ignition on, then

press the Y button to continue, or press the N button to exit.

(Figure 3.25)

Figure 3.25

f) Then an information screen will prompt to show the activated

sensor ID data for confirmation, press Y button to continue the

process, or N button to exit. (Figure 3.22)

g) Once the sensor IDs are successfully written, a confirm screen

will show up, press any key to continue the TPMS Diagnostic

procedure. (Figure 3.23)

IMPORTANT: Make sure to turn the ignition off before connecting

/disconnecting the OBDII Cable to/from the TPMS tool; otherwise it

may cause the Malfunction Indicator Light (MIL) to turn on.