User's Manual Part 1

TPMS Service Operations Relearn Operations
66
 To perform OBDII Relearn function
1. Tap OBDII Relearn to write IDs to the vehicle directly without performing
further procedures.
2. A message will appear when the sensor IDs are successfully written.
5.4.2 Read IDs from vehicle
This function will read sensor IDs from the test vehicle directly.
 To read IDs from vehicle
1. Tap Read IDs from vehicle in the Relearn screen.
2. The Display Tablet will display the sensor IDs and positions for you to
view. Tap OK to save data for future review, or Back to exit.
5.4.3 Read DTC
 To read DTCs
1. Tap Read DTC button from the Relearn screen.
2. A data list of TPMS DTCs retrieved from the vehicle’s ECU will show up.
For more information about read codes, see 4.6.2 Read Codes on page
37.
5.4.4 Clear DTC
 To clear DTCs
1. Tap Clear DTC from the Relearn screen.
2. The Display Tablet will show a warning message for you to confirm. Tap
Yes to continue, or No to exit.
3. If the erase command is sent successfully, the confirming screen will
display. Tap ESC on the confirming screen to exit Clear DTC.
4. Run Read DTC again to ensure the operation is successful.
For more information about DTC erasing, see 4.6.3 Erase Codes on page 38.