User's Manual

Digital Inspection Operations Operations
102
2. Screw the thread part of the accessory over the imager head to fix the
accessory.
16.2 Operations
Before performing the Digital Inspection application, the Imager Head Cable
must be connected to the MaxiSys display tablet through the USB port. Install
the correct imager head accessories for use in the appropriate application.
NOTE: When in operation, the imager head cable can be bent into a certain
shape. This may help you operate the cable into confined areas.
 To take pictures using the Digital Inspection application
1. Connect the Imager Head Cable to the USB port on the top side of
the MaxiSys Display Tablet.
2. If not already done, power up the MaxiSys Display Tablet.
3. Tap the Digital Inspection application on the MaxiSys Job Menu.
The Digital Inspection application interface displays, showing a
camera operating screen. The default camera is now the Imager
head.
4. Select the camera icon at the lower right corner to take photos.
5. Focus the image to be captured in the view finder by adjusting and
properly locating the imager head cable.
6. Tap the blue ring on the operating screen. The view finder now
shows the captured picture and auto-saves the taken photo.
7. Tap the thumbnail image on the top right corner of the screen to view
the stored image, slide the screen left and right to view the images
one by one.