User's Manual

VCI Manager Operations Bluetooth Pairing
84
 To pair the VCI device with the Display Tablet
1. Power on the MaxiSys Display Tablet.
2. Connect the 16-pin end of the data cable to the vehicle data link
connector (DLC).
3. Connect the 26-pin end of the data cable to the J2534 ECU
Programming Device’s vehicle data connector.
4. Tap the VCI Manager application on the MaxiSys Job Menu of the
display tablet.
5. Select Bluetooth from the connection mode list.
6. Tap the Scan button at the top right corner. Now the device starts
searching for available pairing units.
7. Depending on the VCI type you use, the device name may display
as Maxi suffixed with a serial number. Select the required device for
pairing.
8. When paring is successfully done, the connection status displayed
to the right of the device name is shown as Paired.
9. Wait a few seconds, and the VCI button on the system Navigation
bar at the bottom of the screen shall display a green tick icon,
indicating the display tablet is connected to the VCI device.
10. Tap the paired device again to unpair it.
11. Tap the Back button on the top left to return to the MaxiSys Job
Menu.
NOTE: A VCI device can be paired to only one Display Tablet each time,
and once it’s been paired, the device will not be discoverable for any
other unit