User's Manual

12
Installation and Connection
The Display Tablet and Handle Connection
To connect the display tablet and handle, insert the rubber protrusion on the
top right of the display tablet into the corresponding rabbet on the back of the
handle and the round-shaped magnet on the right bottom of the display tablet
into the corresponding round rabbet on the back of the handle (Fig 3-1).
Make sure they are properly aligned for firm connection.
The Imager Heads and Cable Installation
To use the tool, the imager heads and cable must be connected to the handle.
To connect the cable to the handle, make sure the key and slot (Fig 3-2) are
properly aligned. Once they are aligned, finger-tighten the knurled knob to
hold the connection firmly in place.
Figure 3-1