User's Manual

16
Charger Inspection
Before using, inspect the charger and fix any problems. Set up charger
according to these procedures to reduce the risk of injury from electric shock,
fire and other causes and prevent tool damage.
1. Make sure charger is unplugged. Inspect the power cord and charger for
damage or broken, worn, missing, misaligned, binding parts. If any
problems are found, do not use the charger until the parts have been
repaired or replaced.
2. Clean any oil, grease or dirt from the tool especially on the buttons. This
helps to prevent the tool from slipping from your hands and allows proper
ventilation.
3. Inspect if the warning label on charger’s surface is intact and readable.
4. Select appropriate location for charger before using. Check work area
for:
 The charger must be between 10°C (50°F ) and 45°C (113°F) for
charging. If the temperature of either is outside of this range at any
point during charging, the operation will be suspended until the
charger is brought back to the correct temperature range.
 Inspect that the plug fits correctly into the desired outlet.
 The charger needs a clearance of at least 10 cm (4") on all sides to
maintain a proper operating temperature.
Item Description
Battery Type
3.7 V lithium-ion
Battery Capacity
3200 mAh (display tablet)
2600 mAh (handle)
Charging Time
3 hours (display tablet)
2.8 hours (handle)
Cooling
Active fan cooling
Fan (1.8 CFM, 0.05 CMM)