User's Manual

28
Tool and Work Area Set-up
Set up the tool and work area according to these procedures to reduce the
risk of injury from electric shock, entanglement, and other causes and prevent
tool damage.
1) Check work area for:
 Sufficient lighting.
 Do not work in area until flammable sources have been identified
and corrected. The tool is not explosion proof and can cause sparks.
 Do not use the tool while standing in water.
2) Check the area and determine if MaxiVideo
TM
MV500-1 Digital Inspection
Videoscope is the correct tool for the job.
 Check the access to the area.
 Check if there is any electric power supplied to the area to be
inspected.
 Check if any liquid would occur during the inspection. The Imager
heads and cable are waterproof to a depth of 1 m (39.4"), greater
depths may cause leakage into the imager heads and cable and
cause electric shock or damage the tool. The display unit is not
waterproof and should not be exposed to wet conditions.
 Check if any chemicals are present, especially in the case of drains.
Chemicals may damage the tool.
 Check the temperature of the area. The working temperature of the
tool is between 0°C (32°F) and 45°C (113°F).
 Check if any moving parts are present in the area.
3) Make sure the tool has been properly inspected.
4) Install the correct accessories for use in the appropriate application.
IMPORTANT
Make sure the tool has been powered off before performing maintenance.
 Tool maintenance must be performed only by qualified repair personnel.
Maintenance performed by unqualified repair personnel could cause
injury.