Product Manual

53
Chapter 4
Flight Operations
4.1 Preflight Checklist
Follow these steps to carry out a full preflight checkup:
• Fully charge the aircraft battery, remote control, and your mobile device.
• Remove the gimbal holder.
• Verify that the propellers are in proper condition and are correctly attached.
• Position the antennas on the remote control as described in section 3.2.1.
• Pair the aircraft and remote control.
• Verify that the firmware has been updated to the latest version.
• Make sure you are familiar with the flight controls.
• Verify that your flight area is open and unobstructed.
• Check the weather, including air temperature and wind speed.
• Verify that the aircraft's camera lens and sensors are clean.
4.2 Remote Control & Flight Operations
There are three Command Stick Modes available for the aircraft: Mode 1, Mode
2 and Mode 3. Each one controls the aircraft differently. The diagrams below apply
to Mode 2, which is the default. For information on how to change the Command
Stick Mode, see the App Manual.
 Basic Flight
1. Place the aircraft in an open area.
2. Turn on the remote control.
3. Turn on the aircraft and wait for the Rear LED Indicators to flash green slowly.
Stand at least 5 meters (15 feet) clear of the rear of the aircraft.
4. Start the motors and take off using the remote control.