Users Manual

FCC Caution:
Operation of 5150-5250 MHz is restricted to indoor use only.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 ofthe FCC Rules. Operation is subject to the
following two conditions: (1) This device may not causeharmful interference, and
(2) this device must accept any interference received, includinginterference that may
cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmfint erferencul
e to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
is
measures:
Specific Absorption Rate (SAR) information
are conducted using standard operating positions accepted by the FCC with the device
transmitting at its highest certified power level in all tested frequency bands, although the SAR
is determined at the highest certified power level, the actual SAR level of the device while
operating can be well below the maximum value, in general, the closer you are to a wireless
base station antenna, the lower the power output.Before a new model device is a available for
sale to the public, it must be tested and certified to the FCC that it does not exceed the
exposure limit established by the FCC, Tests for each device are performed in positions and
locations (e.g. at the
ear and worn on the body) as required by the FCC.
For limb worn operation, this device has been tested and meets the FCC RF exposure
guidelines when used with an accessory designated for this product or when used with an
accessory that contains no metal.
For body worn operation, this device has been tested and meets the FCC RF exposure
guidelines when used with an accessory designated for this product or when used with an
accessory that contains no metal and that positions the device a minimum of 10mm from the
body.
SAR tests