User manual
Table Of Contents
- User Manual
- EVO Lite Series
- Terms for Usage
- Trademark Information
- Copyright
- Disclaimer
- Data Storage and Use
- Table of contents
- Chapter 1 Read Instructions
- Chapter 2 Aircraft
- ① Propeller
- ④ Gimbal camera
- ② Undercarriage
- ⑤ Front LED indicator
- ③ Forward visual system
- ⑥ Motor
- ⑦ Power button
- ⑨ Rear LED indicator
- ⑧ Rear vision system
- ⑩ Air outlet
- ⑪ SD card slot
- ⑫ Aircraft battery
- ⑬ USB-C port
- ⑭ Ultrasonic sensor
- ⑯ Downward vision system
- ⑮ Downward LED
- The aircraft has one LED indicator at the end of e
- Designated symbol of color:
- R - Red
- Y - Yellow
- G - Green
- B - Blue
- Front LED Indicator
- Back LED Indicator
- Meaning
- B - Normally on
- G - Slow flash(2 secs/1 time)
- Aircraft in GPS mode
- B - Normally on
- Y - Slow flash(1 sec/1 time)
- Aircraft in ATTI mode
- B - Normally on
- Y - Slow flash(1 sec/1 time)
- Low battery warning
- B - Normally on
- R - Slow flash(1 sec/1 time)
- Serious low battery warning
- B - Normally on
- Y - Normally on
- Aircraft under calibration
- B - Normally on
- G - Normally on
- Calibration successful
- B - Normally on
- Y - Normally on
- Calibration failed
- B - Rapid flash
- G - Rapid flash
- Aircraft under pairing
- B - Rapid flash
- G - Normally on 5S
- Pairing successful
- B - Rapid flash
- R - Normally on 5S
- Pairing failed
- B - Rapid flash
- G - Rapid flash
- Aircraft under upgrading
- B - Normally on
- G - Normally on
- Upgrading successful
- B - Normally on
- Y - Slow flash(1 sec/1 time)
- Upgrading failed
- The battery for EVO Lite is 6175mAh and has the ra
- The battery indicator is divided into LED 1, LED
- Chapter 3 Remote controller
- Chapter 4 Autel Sky App
- When shooting night scene videos, users can choose
- Standard: The shooting effect is the same as the n
- Night: it will automatically adjust the ISO value,
- Super Night: it will automatically adjust the ISO
- Chapter 5 Flight
- 1) As shown in figure, press the left and right st
- 2) Slowly push up the left stick.
- 1) Press and slide the one-click takeoff button (
- 2) The aircraft will automatically rise to the hei
- Class I: main airport & low-altitude area for mann
- Class II: Sensitive area or organization & militar
- Chapter 6 Maintenance and service
- Chapter 7 Technical Specification
The aircraft will enter the attitude (ATTI) mode when the GPS signal is poor, the compass is
disturbed and the vision positioning conditions fail to be met. Under the ATTI mode, the
aircraft will drift horizontally, and the intelligent flight function and the return function will
not be available. Therefore, the aircraft under this mode cannot realize spot hover and
automatic brake, so it shall be landed on a safe position as soon as possible to avoid the
occurrence of accident. User shall try to avoid the flight in poor GPS signal, non-ideal light
condition and narrow space, in order to avoid the flight accident due to the ATTI mode.
Important
In the case of flight under the ludicrous mode, the flight speed of the aircraft will
increase largely compared with the normal mode, thus resulting in the substantial
increase in braking distance. In the case of flight without wind, user shall reserve at least
30m of braking distance to ensure flight safety.
In the case of flight under the ludicrous mode, the descending speed of the aircraft will
also increase largely; in the case of flight without wind, user shall reserve at least 10m of
braking distance to ensure flight safety.
In the case of flight under the ludicrous mode, the attitude control sensibility of the
aircraft will increase largely compared with the normal mode. Specifically, any operation
in a small extent on the remote controller will cause a substantial flight action of the
aircraft. In the actual flight, user shall reserve the enough flight space to ensure flight
safety.
After starting shooting under the standard mode or the smooth mode, in order to ensure
the shooting stability, the flight speed will be limited when the gimbal pitch angle is
close to -90° or 0°. In the case of high wind, the limitation will be relieved to improve
the wind resistance of the aircraft. At this time, the gimbal shake may occur.
2.6.2 Intelligent flight features
1. Auto return
The return function is enabled only when there is good GPS signal. To want to enable the
return function manually, long press the return button ( ) on the remote controller or click
the return icon ( ) in Autel Sky App. Upon receipt of the instruction, the aircraft will
automatically return and land on the preset return point.
Important
The return height (relative to take-off point) is 30m by default. If you enable the function