User manual
Table Of Contents
- User Manual
- EVO Lite Series
- Terms for Usage
- Trademark Information
- Copyright
- Disclaimer
- Data Storage and Use
- Table of contents
- Chapter 1 Read Instructions
- Chapter 2 Aircraft
- ① Propeller
- ④ Gimbal camera
- ② Undercarriage
- ⑤ Front LED indicator
- ③ Forward visual system
- ⑥ Motor
- ⑦ Power button
- ⑨ Rear LED indicator
- ⑧ Rear vision system
- ⑩ Air outlet
- ⑪ SD card slot
- ⑫ Aircraft battery
- ⑬ USB-C port
- ⑭ Ultrasonic sensor
- ⑯ Downward vision system
- ⑮ Downward LED
- The aircraft has one LED indicator at the end of e
- Designated symbol of color:
- R - Red
- Y - Yellow
- G - Green
- B - Blue
- Front LED Indicator
- Back LED Indicator
- Meaning
- B - Normally on
- G - Slow flash（2 secs/1 time）
- Aircraft in GPS mode
- B - Normally on
- Y - Slow flash（1 sec/1 time）
- Aircraft in ATTI mode
- B - Normally on
- Y - Slow flash（1 sec/1 time）
- Low battery warning
- B - Normally on
- R - Slow flash（1 sec/1 time）
- Serious low battery warning
- B - Normally on
- Y - Normally on
- Aircraft under calibration
- B - Normally on
- G - Normally on
- Calibration successful
- B - Normally on
- Y - Normally on
- Calibration failed
- B - Rapid flash
- G - Rapid flash
- Aircraft under pairing
- B - Rapid flash
- G - Normally on 5S
- Pairing successful
- B - Rapid flash
- R - Normally on 5S
- Pairing failed
- B - Rapid flash
- G - Rapid flash
- Aircraft under upgrading
- B - Normally on
- G - Normally on
- Upgrading successful
- B - Normally on
- Y - Slow flash（1 sec/1 time）
- Upgrading failed
- The battery for EVO Lite is 6175mAh and has the ra
- The battery indicator is divided into LED 1, LED
- Chapter 3 Remote controller
- Chapter 4 Autel Sky App
- When shooting night scene videos, users can choose
- Standard: The shooting effect is the same as the n
- Night: it will automatically adjust the ISO value,
- Super Night: it will automatically adjust the ISO
- Chapter 5 Flight
- 1) As shown in figure, press the left and right st
- 2) Slowly push up the left stick.
- 1) Press and slide the one-click takeoff button (
- 2) The aircraft will automatically rise to the hei
- Class I: main airport & low-altitude area for mann
- Class II: Sensitive area or organization & militar
- Chapter 6 Maintenance and service
- Chapter 7 Technical Specification
Be sure to turn off the aircraft power switch before turning off the remote controller. Turn
off the aircraft power switch before the arms are folded. First extend the rear arm and
propeller and then the front arm.
2. Turn on aircraft
Press the power button for 3s to turn on the aircraft. The power indicator will be lit to indicate
the current battery level.
3. Pair aircraft and remote controller
Refer to the paragraph 3.4 for this operation procedure.
5.3 Flight operation
This aircraft includes three command stick modes, mode 1, mode 2, mode 3 and each mode
has different control on the aircraft. Please refer to the paragraph 3.2.4 for detailed stick
operation. The default mode is the mode 2 which is recommended for the beginner. The
following flight operations take the mode 2 as an example.
5.3.1 Basic flight
1. Place the aircraft at an open area. Stand at least 3m from the tail of the aircraft.
2. Turn on your remote controller and aircraft.
3. Operate Autel Sky App, connect the mobile device and the aircraft, and enter the camera
interface.
4. Use the remote controller to start motor after the tail LED indicator becomes green and
flash slowly.
5. Slowly push up the lifter to make the aircraft take off stably.
6. Carefully control the aircraft within your range of visibility.
7. Pull down the lifter to land the aircraft.
8. After the aircraft lands on the ground, pull the lifter to the lower position for 2s till that the
motor is turned off.
9. Disconnect the power supply of aircraft and remote controller in turn.