Manual
Table Of Contents
- Chapter 1 Aircraft
- Chapter 2 Remote Controller
- Chapter 3 Smart Battery
- Chapter 4 Autel Enterprise App
- Chapter 5 First Flight
- 5.1 Instructions for First Flight
- 5.2 Flight Precautions
- 5.3 Pre-Flight Preparations
- 5.3.1 Unpacking
- 5.3.2 Charging
- 5.3.3 Preparing the Aircraft
- 5.3.4 Installing/Removing Propellers
- 5.3.5 Preparing the Remote Controller
- 5.3.6 Login, Pairing, Activation (activation only upon first use)
- 5.3.7 Novice Guide (first time use only)
- 5.3.8 Reconnect the aircraft (not required by default, required after disconnection)
- 5.4 Pre-Flight Inspection
- 5.5 Basic Flight Process
- Chapter 6 Firmware Update and Maintenance
- Appendix A Product Specifications
8 Chapter 1 Aircraft
EVO Max 4T User Manual
hinder its movement.
1.2.2 Removing/Installing the Gimbal Camera
Removing the Gimbal Camera
The aircraft adopts a detachable gimbal design, please refer to the following disassembly
steps:
1) Place the aircraft on a level surface with the bottom of the fuselage facing up.
2) Use a Phillips 2.0 screwdriver to unscrew the two screws fixing the "connector
protection cover", as shown in Figure 1-7.
3) Slightly lift the "connector protection cover" and slide it back and up to take out the
gimbal camera, as shown in Figure 1-8 below.
Figure 1-7 Remove the two screws securing the Connector Cover
When turning the aircraft upside down to remove the gimbal camera, please protect the
upward vision system of the aircraft to avoid scratches.