User's Manual

dry and ventilated area at room temperature (ideally 22°C-28°C).
• Do not place the battery beside hard or sharp items, or on a conductive
surface (e.g., metal plate).
• Do not place the battery in wet grass or in the pocket with metal objects.
• Battery electrolytes are highly corrosive. If any electrolytes make contact
with your skin or eyes, immediately wash the affected area with fresh running
water and see a doctor .
• Remove the battery from the aircraft immediately if the aircraft falls into water
during ight. Leave the battery in an open area and keep a safe distance
away until it is completely dry. Never use and charge the battery again.
• Do not use a damaged battery charger.
• Disconnect the charger when not in use and examine the charger’s condition
regularly.
• Do not leave the charging battery unattended.
• Do not charge the battery immediately after using it, as overheat protection
will be activated to prevent the battery from being charged before it has
cooled down completely.
• The battery recharging time varies depending on the remaining battery level.
• Disconnect and remove the Li-Po battery from the aircraft after use to
prevent trickle discharge. During storage, make sure the battery level does
not fall below 3V.
• Since over charging may shorten the battery life, please unplug the charger
once the aircraft and remote controller have been fully charged.
• The heavier the payload, the shorter the ight time will be as more battery
power may be consumed.
• Using or storing the battery in extreme environments may reduce battery life.
• Battery life inevitably shortens over time. And battery life may be reduced if
the battery is left unused over extended periods of time.
• Completely discharge the battery before disposal.
• Dispose the battery properly at specied battery recycling locations.
Reminders
• Flying with an experienced pilot for the rst ight is strongly recommended.
• Keep small or electrical parts out of the reach of children.
• Keep away from heat sources or humid and hostile environments.
• Check the weather before ying, including air temperature and wind speed.
• Make a thorough preight check before each ight ( 27)
• Use only authorized accessories approved or provided by Autel Robotics.
• Do not attempt to disassemble, modify or reconstruct any part of the devices.
Autel Robotics will not be responsible for damages resulting from any
articial reason.
• Do not use this product for illegal purposes.
Services and Support
www.autelrobotics.com
(844)-898-0290 (U.S.A.)
[e-mail]
Or contact your local retail agent for technical assistance.