Users Manual Part 1

43
3. Select a parameter item from the left column, or enter the item name
in the Search bar.
4. Tap the MIN button on the right side, and enter the required minimum
value.
5. Tap the MAX button on the right side, and enter the required
maximum value.
6. Tap the ON/OFF button on the right side of the Alarm button to turn it
on or off.
7. Tap Done to save the setting and return to the Live Data screen; or
tap Cancel to exit without saving.
When the limits are successfully set, two horizontal lines display on
each of the data graphs (when Waveform Graph Mode is applied) to
indicate the alarm point. The limit lines are shown in different colors
for distinction from the parameter waveforms.
 Record – displays the configuration screen for Record Setting, where you
can set the trigger type, duration and trigger point for the data recording
function.
a) Trigger Type – sets the trigger mode for data recording. There are
four options available:
1) Manual – allows you to manually start and stop data recording.
2) DTC – auto triggers data recording when any DTC is detected.
3) DTC Check Mode – auto triggers data recording when certain
pre-selected DTC types are detected.
4) Parameter – auto triggers data recording when any parameter
value reaches the preset threshold.
b) Duration – sets the recording time (for Auto trigger mode only).
c) Trigger Point – reserves a relative percentage of a record length
before the data recording start point for reference (for Auto trigger
mode only).
 To perform setting for live data record
1. Tap the Setting functional button at the bottom of the Live Data
screen.
2. Tap the Record navigation button.