User Manual

7
 Verify that the ignition is ON.
 Check if the scan tool’s OBD II connector is securely
connected to the vehicle’s DLC.
 Verify that the vehicle is OBDII compliant.
 Turn the ignition off and wait for about 10 seconds. Turn the ignition
back to on and continue the testing.
 Verify the control module is not defective.
Operating Error
If the scan tool freezes, then an exception occurs or the vehicle’s ECU
(Engine Control Unit) is too slow to respond to requests. You need to do the
following to reset the tool:
 Reset the scan tool.
 Turn the ignition off and wait for about 10 seconds. Turn the ignition
back to on and continue the testing.
Scan tool doesn’t power up
If the scan tool won’t power up or operates incorrectly in any other way, you
need to do the following to check up:
 Check if the scan tool’s OBD II connector is securely connected to the
vehicle’s DLC;
 Check if the DLC pins are bent or broken. Clean the DLC pins if
necessary.
 Check vehicle battery to make sure it is still good with at least 8.0 volts.
NOTE
Avoid electrostatic interference during operation. If a failure occurs due to
electrostatic interference, Please try to operate again.