User Manual

12
1. Erasing the Diagnostic Trouble Codes may allow the scan tool to delete
not only the codes from the vehicle’s on-board computer, but also
“Freeze Frame” data and manufacturer specific enhanced data. Further,
the I/M Readiness Monitor Status for all vehicle monitors is reset to Not
Ready or Not Complete status. Do not erase the codes before the
system has been checked completely by a technician.
2. Erasing codes does not mean that trouble codes in ECU have been
eliminated completely. As long as there is fault with the vehicle, the
trouble codes keeps on presenting.
3. This function is performed with key on engine off (KOEO). Do not start
the engine.
1) Use the UP/DOWN scroll buttons to select Erase Codes from
Diagnostics Menu and press the OK button.
2) A warning message comes up asking for your confirmation.
Figure 3-7 Sample Erase Codes Screen
 If you do not want to proceed with erasing codes, press ESC button
or use LEFT/RIGHT scroll button to select NO to exit. A message
of “Command Cancelled!” shows up. Wait a few seconds or
press any key to return to Diagnostic Menu.
3) Press the OK button to confirm.
 If the codes are cleared successfully, an “Erase Done!”
confirmation message shows on the display.
 If the codes are not cleared, then an “Erase Failure. Turn Key on
with Engine off!” message appears.
4) Press any button to return to Diagnostic Menu.
Live Data