User Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabili
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using This Manual
- 2 General Introduction
- 3 Getting Started
- 4 Diagnostics
- 5 Service
- 6 Data Manager
- 7 Settings
- 8 Update
- 9 VCI Manager
- 10 Shop Manager
- 11 Academy
- 12 Remote Desk
- 13 MaxiFix
- 14 Support
- 15 Quick Link
- 16 Function Viewer
- 17 Maintenance and Service
- 18 Compliance Information
- 19 Warranty
39
There are four navigation buttons on top of the Setting mode screen.
Selected Button – displays the configuration screen to set the threshold
values, an upper limit and a lower limit, for triggering the buzzer
alarm. This function is only applied to the Waveform Graph display
mode.
a) MIN – tap to display virtual keyboard and enter the required lower
limit value.
b) MAX – tap to display virtual keyboard and enter the required upper
limit value.
c) Buzzer Alarm – switches the alarm on and off. The alarm function
makes a beep sound as a reminder whenever the data reading
reaches the preset minimum or maximum point.
To set threshold limits for the parameter values
1. Tap the Setting functional button at the bottom of the Live Data
screen.
2. Tap the Selected navigation button.
3. Select a parameter item on the left column, or enter the item name
in the Search bar.
4. Tap on the right side of the MIN button, and enter the required
minimum value.
5. Tap on the right side of the MAX button, and enter the required
maximum value.
Figure 4- 14 Sample Setting Mode in Live Data