User Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabili
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using This Manual
- 2 General Introduction
- 3 Getting Started
- 4 Diagnostics
- 5 Service
- 6 Data Manager
- 7 Settings
- 8 Update
- 9 VCI Manager
- 10 Shop Manager
- 11 Academy
- 12 Remote Desk
- 13 MaxiFix
- 14 Support
- 15 Quick Link
- 16 Function Viewer
- 17 Maintenance and Service
- 18 Compliance Information
- 19 Warranty
61
Tap continue to the next step.
Figure 5- 16 Sample SAS Function Screen 1
3) The run flat indicator must be additionally initialised after adjusting
the steering angle sensor on completion of the following work:
-Encoding of DSC control unit
-Replacement of DSC control unit
Tap continue to proceed.
Figure 5- 17 Sample SAS Function Screen 2