User Manual
38
NOTE
This mode supports Graph Merge for 2 to 3 parameter items only, select no less than 2
or more than 3 items each time when making graph merge.
➢ To cancel Graph Merge mode, tap the drop-down button on the right side of the
parameter name, and select a data display mode.
Show Selected/Show All – tap button to exchange between the two options;
one displays the selected parameter items, the other displays all the available
items.
Setting – tap button to open a setting screen, which allows you to set the
trigger mode, recording duration, and various threshold values for data
recording, and make other controls.
Figure 4-12 Sample Setting Mode in Live Data
There are four navigation buttons on top of the Setting mode screen.
⚫ Range – displays the configuration screen on which you can set the
threshold values, an upper limit and a lower limit, for triggering the buzzer
alarm. This function is only applied to the Waveform Graph display mode.
a) MIN – tap button to open a virtual keyboard to enter the required
lower limit value.
b) MAX – tap button to open a virtual keyboard to enter the required
upper limit value.
c) Buzzer Alarm – switches the alarm on and off. The alarm function
makes a beep sound as a reminder whenever the data reading
reaches the preset minimum or maximum point.
➢ To set threshold limits for the parameter values
1. Tap the Setting button at the bottom of the Live Data screen.
2. Tap the Range navigation button.