AL329 User Manual V1.00

7
Configure Monitors
From System Setup screen, use the SCROLL button to select Configure
Monitors, and press the ENTER/Exit button.
Figure 2-5 Sample Configure Monitors Screen
On this menu, configure the monitors to pass diagnosis, and restore the
default settings.
Allowed INC Monitors
From Configure Monitors screen, use the SCROLL button to select
Allowed INC Monitors, and press the ENTER/Exit button.
Emissions tests vary depending on the geographic or regional area in which
the vehicle is registered. To this, the scan tool provides a more flexible way
to meet different standards by allowing the user to select 0, 1, 2, or 3 “not
complete” monitors in test.
Reset Factory Default
From Configure Monitors screen, use the SCROLL button to select Reset
Factory Default, and press the ENTER/Exit button.
It will restore the default configuration settings in the Configure Monitors
menu, and delete any customized settings. In this case, the Allowed INC
Monitors will be set to 1.
The tool will display a message for your confirmation. Use SCROLL button
to select Yes to proceed or No to exit without change.
Unit of Measure
 Metric is the default measurement unit.
1) From System Setup screen, use the SCROLL button to select Unit of
Measure and press the ENTER/Exit button.