AL329 User Manual V1.00

26
 BP – Boost Pressure System Monitor
 EGS – Exhaust Gas Sensor Monitor
 PM – PM Filter Monitor
Figure 3-14 Sample Since DTCs Cleared Screen
5) If the vehicle supports readiness test of This Drive Cycle, a screen of
the following displays.
Figure 3-15 Sample This Drive Cycle Screen
6) The LEDs and audio tones corresponding to different monitor status will
be activated as below.
Table 3-2 LED and Audio Tone Interpretation
LED Light
Audio Tone
Beep Interval
Green
Two long beeps
2 minutes
Yellow
short, long, short beep
2 minutes
Red
Four short beeps
2 minutes
7) Use the SCROLL button for more PIDs if additional information is
available on more than one page.
8) Press the ENTER/Exit button to return to Diagnostic Menu.