Safety Information

103
The amplitude settings allow you to set up the multimeter to capture signals within
the specified range. If the input signal exceeds the selected range, an over-range
indicator will be displayed. Select Auto to enable the device to adjust the vertical
scale automatically.
There are two modes available to set the amplitude value.
Mode 1: For example, selecting DC 10V sets the amplitude to Voltage 10V
(displays on the amplitude button). The vertical scale range is from -10V to +10V.
As the vertical scale is divided into 10 segments, each segment increases by 2V.
Figure 1-17 Channel Setting Dialog Box Screen (DC 10V)
Mode 2: Select the ## /div button to adjust the value increments of each division.
For example, selecting DC 2.0V/div, sets the amplitude to Voltage 2.0V/div
(displays on the amplitude button). Each segment increases by 2V. As the vertical
scale is divided into 10 segments, the entire vertical scale range is from -10V to
+10V.