Safety Information

137
1.4.2 General Introduction
1.4.2.1 Component Locations
The main connectors are located at the bottom of the VCMI device.
1. Ethernet Connector
2. Vehicle Data Connector
3. Input Channel A
4. Input Channel B
5. Input Channel C
6. Input Channel D
1.4.3 Getting Started
Before opening the OBDII CAN Bus Check application, you have to complete three
steps below:
1) Connect the VCMI device to the Tablet via Wi-Fi or the supplied USB.
2) Connect the VCMI device to the vehicle’s OBDII connector.
3) Place the ignition in the key on position.