Safety Information

146
Figure 1-10 Sample Indicator Mode Screen
Main View Section
The CAN-High line is assigned to Pin 6 and the CAN-Low line is assigned to Pin 14 of
the OBDII adapter by default according to the CAN-Bus standard protocol.
If the test vehicle’s actual communication signal pins are assigned differently, you can
select OBDII connector’s signal pins manually in the Settings Menu.
When the electronic control units send out signals properly, the left and right indicator
lights will flash consecutively on the screen.
NOTE
The flashing indicator lights serve to confirm only that communication signals have
been detected.
Lower Buttons
 Protocol Button
In the left lower corner of the screen, you can select the protocol you want to test.