Dragonfish PAD Remote controller user manual Power button of the android PAD, for power on and off, and close/on the LCD. The main APP.
When connect the wifi of base station, Power on the base station, and follow the up steps to connect the wifi of base station.
When connect the UAV through base station, follow the up steps to setup.
When connect the UAV direct, and match the RF connection, setup the up steps.
RF Block diagram: Dragonfish PAD Remote controller wireless datasheet A. Overview Dragonfish PAD Remote controller contain the following 5 wireless modules: 1. 900M/2.4GHz image transmit module,fix 1T2R work mode,only one frequency band operates in the same time period. Default operates in 2.4GHz band. System can automatically open 900MHz band when the GPS location is in North America; 2. System 2.G/5.8G dual-band wifi module,fix 2T2R work mode,only one frequency band operates in the same time period.
B. Block diagram C. Three working modes: 1. PAD working but not connect base station, not connect UAV Only android wifi 0 work, wifi 1 for base station can work when start dragonfish app. 5.8G remote controller works in receive mode; 900M/2.4G image transmit module closed。 2. PAD working normal mode: wifi 1 connect base station, base station connect UAV wifi 0 module works in 2.4G band; wifi 1 module works in 5.8G band and connect base station, 5.8G remote controller connect UAV;900M/2.
FCC Warning Message Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
IC STATEMENT This device complies with Industry Canada licence-exempt RSS standard(s) Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance.