User Manual

69
Figure 8.8
B. Cable tensioning
Once the brake cable is fit in, you would use this function to adjust
its tension. It will take a few seconds to execute this command.
Figure 8.9
When the job is done successfully, the tool will display a message
to confirm.
Figure 8.10
If the job fails to finish, the tool will display a message to remind
user of a problem. After you exit the diagnosis program, please
repair the problem immediately.
Put in fitting/removal position
Activation done, a problem
occurred during the operation.
Press any key to continue
OK
Cable tensioning
Cable tensioning done.
Now calibrate the Electric parking
brake (See “Brake cable
replacement” menu)
Press any key to continue
OK
Cable tensioning
Activation in progress!
OK