Product Specs

8
1. On the left side of the crossbar, insert the long power supply cable into the first inner
hole of the crossbar. Ensure that the cable is fully passed through the entire crossbar,
and that the connector of the power supply cable (Pos.1) is exposed at the opposite
end of the crossbar.
2. Insert the long signal cable attached to the left camera unit into the third inner hole
from the same end of the crossbar. Ensure that the cable is fully passed through the
entire crossbar, and that the connector of the long signal cable (Pos.2) is exposed
at the opposite (right) end of the crossbar.
Figure 3-3 Cables Fully Passed Through Crossbar
1. Insert the side segment of the camera unit into the left end of the crossbar, and place
the two short cables into the fourth slide slot.
2. Align the bolt holes on the side segment with the screw holes on the sliding nuts
(M6), insert two bolts (M6x14) into the screw holes, and then tighten bolts with the
hex L-wrench until the camera unit is secured.