User Manual

123
NOTE: The ECU must be re-adapted when replacing the DPF
and when topping up the fuel additive Eolys.
NOTE: All software screens shown in this manual are examples,
and actual test screens may vary for each vehicle being tested.
Observe the menu titles and onscreen instructions to make
correct option selections.
NOTE: If the vehicle needs to be driven in order to perform a
DPF service, ALWAYS have a second person help you. One
person should drive the vehicle while the other person observes
the screen on the Tool. Trying to drive and observe the Scan Tool
at the same time is dangerous, and could cause a serious traffic
accident.
Take BMW as an example. Follow the steps below to do the tests.
1. Turn the ignition off.
2. Locate the vehicle’s 16-pin Data Link Connector (DLC).
3. Plug the scan tool cable connector into the vehicle’s DLC.
4. Turn the ignition on, and the engine may be off or running.
5. Turn on the scan tool and wait for the Main Screen to appear.
6. Use the UP/DOWN scroll button and LEFT/RIGHT scroll
button to select DPF in the Main Screen (Figure 3.1).
7. Wait for a series of vehicle identification screens appears for user
to identify the vehicle. On each screen that appears, use the
UP/DOWN scroll button to select the correct option and then
press the OK button. Do this until the vehicle is completely
identified.