User Manual

33
B. This Drive Cycle - indicates status of monitors since the
beginning of the current drive cycle.
An I/M Readiness Status result of “NO” does not necessarily
indicate that the vehicle being tested will fail the state I/M
inspection. For some states, one or more such monitors may be
allowed to be “Not Ready” to pass the emission inspection.
 OK -- Indicates that a particular monitor being checked has
completed its diagnostic testing.
 INC -- Indicates that a particular monitor being checked has
not completed its diagnostic testing.
 N/A -- The monitor is not supported on that vehicle.
1) Use the UP/DOWN scroll button to select I/M Readiness from
Diagnostic Menu and press OK button (Figure 5.3).
2) Wait a few seconds while the scan tool validates the PID MAP.
3) If the vehicle supports both types of tests, then both types will be
shown on the screen for selection (Figure 5.20).
Figure 5.20
4) Use the UP/DOWN scroll button, as necessary, to view the status
of the MIL light (“ON” or “OFF”) and the following monitors:
For spark ignition engines:
 MIS -- Misfire Monitor
 FUEL -- Fuel System Monitor