User Manual

60
engine electronics, press the OK button to end the service
function.
Figure 6.32
 If the replaced battery has a different type from the original one,
select [3] with the LEFT/RIGHT scroll button and press the OK
button to continue.
Figure 6.33
 Refer to the steps described for registering the replaced battery
with higher/lower capacity.
NOTE: Please follow the instructions shown on screen to
proceed when performing the registration procedure.
6.3 Close-circuit Current
The close-circuit current should always be measured if increased
current consumption is suspected. Battery will discharge at a relatively
fast rate even current consumption rates slightly above the normal.
Register battery replacement
The battery replacement was successfully
logged in the engine electronics.
To register the new battery size or the
other battery type, now carry out the
following retrofit in diagnostic tools: -
Batter
OK
Register battery replacement
Original battery type and battery capacity
acc to vehicle order: 105 Ah AGM
[1] Enter battery replacement: same
capacity
[2] Enter battery replacement:
higher/lower capacity