User Manual

63
Figure 6.39
4) Press the corresponding FUNCTION button [Yes] to send the
power-down command, or press the corresponding FUNCTION
button [No] to exit this function.
5) After the command is sent, follow the instructions on the screen
and press the OK button to continue.
Figure 6.40
6) Press the OK button to end the service function.
Figure 6.41
Power down command
With the power-down command, the
vehicle is brought to rest mode within a
short time:
-Switch-off terminal 15 via activation
command
-Sending the power-down command
-Go to sleep of bus system and switch-off
Yes No
Power down command
The power-down command was sent!
Now interrupt the procedure at the Scan
Tool and then disconnect the tool from
the diagnosis socket. Leave the vehicle
in rest mode! It can take up to 2 minutes
until the vehicle reaches its closed-
circuit current value.
OK
Power down command
End service function. Continue in
testing schedule.
OK