User Manual

6.5 Charging Battery via Diagnostic Socket

This function can delete the transport mode of the control unit and

allows the battery charging via the OBD II port.

1) Use the UP/DOWN scroll button to select Charging the battery

via diagnostic socket option from the Power supply (Battery)

menu and press the OK button.

Figure 6.42

2) Read carefully the instructions on the screen and press the OK

button to continue.

Figure 6.43

3) Press the corresponding FUNCTION button [1] and press the

OK button to delete the transport mode of the control unit.

Power supply (Battery)

1. Battery

2. Close-circuit current

3. Activate rest state

4. Charging battery via diagnostic

socket

5. Auxiliary battery (24V EPS):

Charging battery via diagnostic

When the transport mode is active,

terminal 30g-f and/or terminal 30F

will be switched off shortly after the

vehicle goes to sleep: Charging the

battery with a solar charger using the

diagnostic socket is then not possible.

This service function can be used to