User Manual

87
the operation of the brake cables statically. If you start the
actuator test, you must wait for the component to stop
operating before starting another actuator test. Press 'OK' to
apply the electric parking brake or press 'Cancel' to go back
to the list of possible operation.” Select OK to continue or
Cancel to exit.
4. The tool may display information during and after the test. The
information varies by vehicle.
Figure 8.19
5. When the test is finished, there may be three results displaying
on the screen.
 The test is finished successfully.
 The test is stopped by the user.
 The test did not finish.
In the first condition, the tool will display an information screen as
“The operation was performed correctly. Put the vehicle on a
vehicle lift and check that the rear wheels are locked. Check that
the 'Electric parking brake on' message is display on the control
panel and that the LED illuminates on the control panel.”
In the second condition, the tool will display an information screen as
“Operation of the actuator test was stopped by the user. Press
‘Cancel' to go back to the list of possible operations.”
In the third condition, the tool will display an information screen as
“The actuator test did not finish operating. Please perform the
following check: Read the faults to resolve any possible faults
Apply electric parking brake
Listen to the noise of the Electric
motor!
OK