User Manual

9. ABS/SRS

The ABS/SRS diagnostic function is used to retrieve and clear DTCs,

display and save data streams or module information, and perform

various function tests on the vehicle’s ABS/SRS systems. It also

provides the definition of each trouble code to help diagnose problem

areas within the system that have caused the Malfunction Indicator

Light to turn on.

NOTE: AUTEL accepts no responsibility for any accident or

injury arising from servicing the ABS/SRS systems. When

interpreting DTCs retrieved from the vehicle, always follow the

manufacturer’s recommendation for repair.

NOTE: All software screens shown in this manual are examples,

actual test screens may vary for each vehicle being tested.

Observe the menu titles and onscreen instructions to make

correct option selections.

Please follow these steps to start the ABS/SRS diagnostic testing

procedure:

1) Turn the ignition off.

2) Locate the vehicle’s 16-pin Data Link Connector (DLC).

3) Plug the scan tool cable connector into the vehicle’s DLC.

4) Turn the ignition on but do not start the engine.

5) Turn on the scan tool and wait for the Main Screen to appear.

6) Use the UP/DOWN scroll button and LEFT/RIGHT scroll

button to select AbsSrs in the Main Screen (Figure 3.1).

9.1 Vehicle Selection

There are three ways for users to enter the vehicle information in the

scan tool.