User Manual

22
displays.
 To submit Data Logging reports in Diagnostics
1. Tap the Diagnostics application button from the MaxiCOM Job
Menu. The Data Logging button on the diagnostic toolbar is
available throughout the Diagnostics operations.
2. Tap the Data Logging button. The button displays blue during the
active recording process.
3. Tap the Data Logging button again to end recording. A submission
form will display for inputting of report information.
4. Tap the Send button to submit the report form via the Internet. A
confirmation message displays when the report has been
successfully sent.
Status Information Bar
The Status Information Bar at the top of the Main Section displays the
following items:
1. Menu Title – displays the menu heading of the Main Section.
2. Voltage Icon – displays the vehicle’s voltage status.
Main Section
The Main Section of the screen varies depending on the stage of operations.
The Main Section can display vehicle identification selections, the main menu,
test data, messages, instructions and other diagnostic information.
Functional Buttons
The displayed Functional Buttons vary depending on the stage of operations.
Functional buttons can be used to navigate menus, to save or clear diagnostic
data, to exit scanning and to perform a number of other control functions. The
use of these buttons will be discussed in detail in the following sections of the
corresponding test operations.