User Manual

ManualsBrandsAutel ManualsAutomotiveScanner MK808 Diagnostic Scan Tool 2021 Newest with All System Diagnosis, 25+ Maintenance Functions Services Including IMMO, Oil Reset, EPB, BMS, SAS, DPF, ABS Bleed

Table Of Contents

Trademarks
Copyright Information
Disclaimer of Warranties and Limitation of Liabilities
For Services and Support
Safety Information
Safety Messages
Safety Instructions
1 Using this Manual
- Conventions
2 General Introduction
- MaxiCOM MK808 Display Tablet
- Accessory Kit
  - Main Cable
  - Other Accessories
3 Getting Started
- Powering Up
- Powering Down
  - Reboot System
4 Diagnostics
- Getting Started
  - Vehicle Menu Layout
  - Top Toolbar Buttons
    - Manufacturer Buttons
- Vehicle Identification
- Navigation
- Diagnosis
  - Auto Scan
  - Control Units
- Generic OBD II Operations
  - General Procedure
  - Function Descriptions
- Exiting Diagnostics
5 Service Operations
- Oil Reset Service
- Electronic Parking Brake (EPB) Service
  - EPB Safety
  - EMF Star-up
    - Parking Brake: Workshop Mode
- BMS
  - Register Battery Replacement
- Steering Angle Sensor (SAS) Service
  - Steering Angle Sensor Calibration
- DPF Service
- Tire Pressure Monitor System (TPMS) Service
- IMMO Service
6 Shop Manager
- Vehicle History
  - Historical Test Record
- Workshop Information
- Customer Manager
  - History Notes
7 Data Manager
- Operations
8 Settings
- Unit
- Language
- Printing Setting
- Notification Center
- Auto Update
- About
- System Settings
- Firmware
9 Update
10 Support
- Product Registration
- Support Screen Layout
- My Account
- User Complaint
- Data Logging
- Communities
- User Profile
- Training Channels
- FAQ Database
11 Academy
12 Remote Desk
13 MaxiFix
- Navigation
- Operations
14 Quick Link
15 Function Viewer
16 Maintenance and Service
- Maintenance Instructions
- Troubleshooting Checklist
- About Battery Usage
- Service Procedures
17 Compliance Information
- FCC Compliance FCC ID: WQ8-1610MX808
18 Warranty
- Limited One Year Warranty
  - This warranty does not apply to:

3. Select a specific protocol under the Protocol option. Wait for the

OBD II Diagnostic Menu to display.

NOTE

Tapping the

○

i button beside the function name to display additional

function information.

4. Select a function option to continue.

 DTC & FFD

 I/M Readiness

 Live Data

 On-Board Monitor

 Component Test

 Vehicle Information

 Vehicle Status

NOTE

Some functions are supported only on certain vehicle manufacturers.

Function Descriptions

This section describes the various functions of each diagnostic option:

Figure 4-14 Sample OBD II Diagnostic Menu