User Manual

48
Parking Brake: Workshop Mode
This service is used to activate and deactivate the so-called installation
position for the Automatic Hold brake. In this mode, the parking brake is
moved into the opened position and temporarily deactivated for personal
protection.
The installation position must be activated for the following repairs:
 Replacement of brake pads.
 Replacement of a brake caliper.
 Replacement of an actuator.
Select Parking Brake: Workshop Mode and follow the on-screen
instructions to perform a series of operations to start the brake pad after
replacement.
When the operation is successfully completed, a “Completed successfully”
message will appear on the screen. Press OK to exit.
BMS
The BMS (Battery Management System) allows the scan tool to evaluate the
battery charge state, monitor the close-circuit current, register the battery
replacement, and activate the rest state of the vehicle.
NOTE
1. This function is not supported by all vehicles. The screens shown in this
section are examples.
2. The sub functions and actual test screens of the BMS may vary by
vehicle. Please follow the on-screen instructions to make the correct
selection.
The vehicle may use either a sealed lead-acid battery or an AGM (Absorbed
Glass Mat) battery. Lead acid battery contains liquid sulphuric acid and can
spill when overturned. AGM battery (known as VRLA battery, valve regulated
lead acid) also contains sulphuric acid, but the acid is contained in glass mats
between terminal plates.
It is recommended that the replacement aftermarket battery have the same
specifications, such as capacity and type, as the battery in the vehicle. If the
original battery is replaced with a different type of battery (e.g. a lead-acid
battery is replaced with an AGM battery) or a battery with a different capacity
(mAh), the vehicle may require reprogramming the new battery type in