User Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using this Manual
- 2 General Introduction
- 3 Getting Started
- 4 Diagnostics
- 5 Service Operations
- 6 Shop Manager
- 7 Data Manager
- 8 Settings
- 9 Update
- 10 Support
- 11 Academy
- 12 Remote Desk
- 13 MaxiFix
- 14 Quick Link
- 15 Function Viewer
- 16 Maintenance and Service
- 17 Compliance Information
- 18 Warranty
55
3. Tap the needed service in the SAS function list. The list may vary by
vehicle.
Steering Angle Sensor Calibration
This function allows users to perform steering angle sensor calibration and
clear records. Available function options vary by vehicle.
1) Tap Steering Angle Sensor Calibration from the SAS function menu
to enter the function screen.
2) Follow the on-screen instructions to set the ignition on/off as guided. The
vehicle battery voltage signal should be in the range 12.5 – 13.5 volts to
proceed with this service, otherwise the scan tablet will display a warning
message.
3) Make sure the steering wheel is in the center position and the front
wheels are straight. Then tap OK to proceed.
Figure 5-18 Sample SAS Function Menu