User Manual
Table Of Contents
- Trademarks
- Copyright Information
- Disclaimer of Warranties and Limitation of Liabilities
- For Services and Support
- Safety Information
- Safety Messages
- Safety Instructions
- 1 Using this Manual
- 2 General Introduction
- 3 Getting Started
- 4 Diagnostics
- 5 Service Operations
- 6 Shop Manager
- 7 Data Manager
- 8 Settings
- 9 Update
- 10 Support
- 11 Academy
- 12 Remote Desk
- 13 MaxiFix
- 14 Quick Link
- 15 Function Viewer
- 16 Maintenance and Service
- 17 Compliance Information
- 18 Warranty
60
2. The tool communicates with the vehicle and reads the fault codes
memory. Follow the on-screen instructions to finish this procedure.
3. Then the tool will display as below. Press the corresponding number
button to perform the desired function.
[1] Enter New Value for Adjustment
From the Injection Rate menu, tap [1] and the screen displays as below.
NOTE
The data you input should be in the defined range. If the input data is out of
range, the tool will display a warning message “Permissible adjustment range
exceeded.”
Figure 5-24 Sample Injection Rate Screen
Figure 5-25 Sample Enter Value Screen