User Manual

48
⚫ This Driving Cycle – displays the status of monitors since the beginning of the
current drive cycle.
Live Data
This function displays the real time PID data from ECU. Displayed data includes analog
inputs and outputs, digital inputs and outputs, and system status information broadcast
on the vehicle data stream.
Live data can be displayed in various modes, see Live Data on page 35 for detailed
information.
O2 Sensor Monitor
This option allows retrieval and viewing of O2 sensor monitor test results for the most
recently performed tests from the vehicle’s on-board computer.
The O2 Sensor Monitor test function is not supported by vehicles that communicate
using a controller area network (CAN). For O2 Sensor Monitor tests results of
CAN-equipped vehicles, refer to On-Board Monitor.
On-Board Monitor
This option allows you to view the results of On-Board Monitor tests. The tests are
useful after servicing or after erasing a vehicle’s control module memory.
Component Test
This service enables bi-directional control of the ECM so that the diagnostic tool is able
to transmit control commands to operate the vehicle systems. This function is useful in
determining how well the ECM responds to a command.
Vehicle Information
The option displays the vehicle identification number (VIN), the calibration identification,
and the calibration verification number (CVN), and other information of the test vehicle.
Vehicle Status
This item is used to check the current condition of the vehicle, including communication
protocols of OBD II modules, retrieved codes amount, status of the Malfunction
Indicator Light (MIL), and other additional information may be displayed.
Exit Diagnostics
The Diagnostics application remains open as long as there is an active communication
with the vehicle. You must exit the diagnostics operation interface to stop all
communications with the vehicle before closing the Diagnostics application.